symantec endpoint manager restart services

Symantec endpoint manager restart services install#
Symantec endpoint manager restart services full#

* This issue can occur if folder permissions are not correct on the 'Symantec Endpoint Protection Manager' folder.ġ. See this article for more information: 'Which communication ports does the Symantec Endpoint Protection Manager 11.x use?'

Verify that no other process is listening on TCP ports 8443, 9090 or 8005Ģ. * If there is already an application listening on one of the TCP ports the console is configured to use it can also cause the service to fail.ġ. Verify that the 'Symantec Embedded Database' service is running and that the dbsrv9.exe process is listening on TCP port 2638. * If configured to use the embedded database verify that it is running and reachable.ġ.

Verify the connection to the SQL database from the SEPM machine. * If configured to use a Microsoft SQL server and the database is down or the machine unreachable this can also cause the SEPM service to shut down.ġ. Once this is completed the Symantec Endpoint Protection Manager service should start properly again. Open up the 'Management Server Configuration Wizard' from the start menu and walk through the 'Reconfigure the management server' wizard to make sure all settings for the database are correct.

Symantec endpoint manager restart services install#

* If you see this error just after an install or a database reconfiguration or restore then the error might be caused by incomplete database settings.ġ. If running on a 64bit machine IIS needs to be in 64bit mode(default but can be changed by other programs if IIS is running other sites before the install of the manager. To correct this go to the Properties dialog of the Default Web Site (or the site configured during the install) in the IIS management console and change the IP address binding back to (All Unassigned).Ģ. * This issue can happen if the SEPM web server in IIS is set to bind to a specific IP address instead of (All Unassigned) which is the default.ġ.

Symantec endpoint manager restart services full#

Most common are problems connecting to the database but examine the full list of possible causes below. This problem can have several different causes. In the event log there is an error: 'The Java Virtual Machine has exited with a code of -1, the service is being stopped'. The Symantec Endpoint Protection Manager (SEPM) 11.x service 'SemSrv' stops a few seconds after it has been started.